Installation Guide

(Fis.1
e)
The adjustment for the hexangular vertical shaft
Adjust the nut
(14)
and
(15)
lightly
until
it lock well.
The adjustment for
the
fixing
shaft of
horizontal
arm
*Turn
the
handle
(13)
to the
position
shown as the figure, make the cross adapter
(8)
reach the fixed
plate
(7).
*Turn
the swing arm to the
outside
fully,
then loose the nut
(3),
and
loose the
screw
(2)
about
20mm,
*Push
the
fixed
shaft
(1)
by hand to make it
slide
freely, then rotate the
screw
(4)
out slowly, till
the
extreme
position
of
fixed
shaft
(1),
then tighten the nut
(5).
-Tighten
the screw
(2)
fully,
and
turn
one circle back, then tighten the
nut
(3).
-lf
it
still does
not lock well
afterthe above steps, loose the nuts
(11), (9),
then rotate the bolt
(10)
to make it short, then tighten
the nuts
(11), (9),
the fixed shaft
(1)
will lock well.
The adjustment for
the completely automatic
machine
Do
the adjustment as
follow
steps, if the vertical shaft does not lock well.
Shut off the
pneumatic
supply, demount the vertical
shaft cover,
then
adjust
the nut near the thread rod
by spanner, or
lock the
screw
in front
of the
plate,
then
connect
the
pneumatic
supply and observe the
locked
position.
Do the adjustment as follow
steps,
if
the
horizontal
arm does
not move
smoothly, or
not lock well.
Remove the
cover on the tilt column, adjust the screw MG on two sides by spanner, meanwhile
push
the horizontal arm till it
can move smoothly, then
tighten the
nut
and adjust the screw
in
the middle
by spanner,
lock the horizontal
arm and observe
the change, till
it
can only move in the range of 2mm, then lock the nut.
) Read
fhe user's manual and teclmical data according to the type of the machine, The users will not be informed,
if this manual has some changes.
I