Symbol and code printed In the manual, the following symbols and codes is for the convenience of reading. ‘— need careful operation ® prohibited may cause dangerous to the operator Bold Important info Warning: Before lifting and any adjustment, carefully read the Chapter 7 “Installation” among which it is the operation suitable for the best lift.
Chapter 1 Introduction 1. introduction Thinks for you purchase this product from the series products of tire changers. This product is based on the jest quality principal, Following the simple instruction in this manual can ensure the correct operation and prolong the Rife of the machine.
ramparts assembly 4.2.4Arm assembly Carefully read the manual before installation, any modification to the parts without the permission of the manufacturer may cause the garage to the machine. The personnel to execute commission must have some knowledge of electricity. The operator must under the special trained and be authorized. Carefully chick the equipment list, If any question, contact the dealer or the manufacturer immediately.
Fig 46 4.2.10 Insert the piston rod from the hole of the bead breaker slide bushing (Figs-7-1) The plane of the slide bushing face outwards (Figs-7) . Screw the screws defaced into the front end of the piston rod. Fig 4-7 4.2.11The distance from the ship of the bead breaker blade to the wheel support is 30~40mm Fig 4-6 crystallization of air regulator When out of factory, detach the air regulator and place into the accessory box. The customer should install at site.
Check i the characteristics of your system nest the requirements of the machine. If you have to change the voltage of the machine, please refer to the electrical scheme in Chapter$ to adjust the termination board. Connect the inlet of the air regulator (Figs-14 -17) through the machine with the compressed air system. Connect the machine with the electrical system which is equipped with fuse, Perfect ‘.
"‘ To avoid damaging the tube, you should é If remounting tire is jammed, stop the position the valve at the right side of the running at once. Lift up the pedal and tool head, the distance should be rotate the turntable counterclockwise to 10cm (Sigh-3) remove the jamming ! Necklace, bracelet, loosen clothes or ® the movable foreign objects near will damage the operator.
inflating. If require relative high pressure, detach the tire from the turntable and place’ into the inflation cage. Never exceed the pressure the manufacturer suggests. Hand and part of body should be at the rear sine of the tire being inflated. Only the professional personnel trained, the others should not operate the machine or at the zone nor the fire changer. Chapter Maintenance 71 Note The routine maintenance described in the manual is execute the maintenance.
ITS ABSOLUTELY FORBIDDEN TO INFLATE THE TIRE ON THE TIRE CHANGER The manufacturer has the right to modify the products without notification the buyer in advance
