Installation Guide

shaft cap, you need use the lock handle to lock the

hexangular shaft to avoid sliding off to damage the

machine or injury personnel!

Install the vertical shaft spring（FIG7-1）on the vertical

shaft. Mount the vertical shaft cap and mount the

removed screw and assemble the hand wheel into the

nut bushing of the rocker arm（FIG 7-2）。

3.2.4Remove the lock nut at the front end of the bead

breaking cylinder piston rod（FIG 8-1）and use the

wrench to remove the nut on the bead breaking arm

bolt（FIG8-4） Remove the bolt（FIG8-3）and hang the

spring（FIG8-2）

FIG6

FIG 7

FIG 8

3.2.5Position the bead breaking arm shaft bushing into

the bead breaking support plate on the body（FIG 9-1 to

align the hole and install the bead bre3aking bolt

（FIG9-2）and assemble the nut to lock（FIG 8-4）.

Insert the piston rod（FIG10-2）through the hole of the

bead breaking slide bushing(FIG10-1）. The surface

of the slide bushing should be outwards（FIG 10）.

Assemble the removed nut（FIG 8-1）into the front end

of the piston rod. The nut will be assembled. The

distance from the edge of the bead breaking blade to

the bead breaking rubber is 30～40mm（FIG11）. Hang

the spring.（FIG9-3）。

FIG 9