Installation Guide

TROUBLESHOOTING REASON SOLUTION

Turntable rotates in one direction. Universal switch contact burned Change Universal switch

Turntable does not rotate. Belt damage

Belt too loose

Motor or power source have problems

Universal switch contact damage

Change belt

Adjust the tension of the belt

Check motor, power source and power source

cable

Change motor

Change Universal switch

Turntable can not clamp the rim as

normal

Claw worn

Clamp cylinder air leakage

Change claws

Change the air leakage sealing parts

hexangular shaft

cannot lock

Lock plate not in position

See Chapter V

Chassis pedal not return. Pedal return spring damage Chang torsion spring

Motor not rotate or the output

torque not enough

Drive system jam

Capacitor broken down

Voltage not enough

Short-circuit

Remove the jam

Change capacitor

Wait for the restore of the voltage

Remove

Cylinder output force not enough Air leakage

Mechanic fault

Air pressure not enough

Change sealing parts

Remove the fault

Adjust the air pressure to meet the requirement

Air leakage Air pipe damage

Pipe connect damage

Sealing end damage

Sealing glue missing

Change damaged parts

Add sealing glue