Installation Guide

12
3. In the process of inflation, you should repeat
switching the inflation gun to confirm
the pressure indicated on the pressure gauge not
exceed the scope specified by the manufacturer.
4. If the inflation pressures too high, you can press
down the deflation press button on the inflation device
to reach the required air pressure.
Warning！Explosive！
When inflating, please obey the following instructions:
*Carefully check if the tire and the rim are of the same
dimension and check the wear condition of the tire to
confirm the tire not damaged before inflation.
* When the air pressure needed for inflation relatively
high, you can take off the tire and to inflate under the
protective cover.
* When inflating the tire, please be carefully. Keep your
hands and body away from the tire.
Chapter V MAINTANENCE & REPAIR
NOTE：
Only the qualified professional personnel can execute
the maintenance. Before any maintenance, Cut off the
power .And ensure the maintenance personnel can
take charge of the power plug. Meanwhile, cut off the
air supply and pull off the quick adaptor of supply and
completely deflate the residual air in the machine.
To correctly use the tire changer and prolong its
working life, it is necessary to periodically maintenance
and repair according to the instruction manual. Or the
running and reliability of the machine will be affected
and the personnel near the machine or the operator will
be injured.
The following position should be monthly maintenance：
Keep the machine and working area clean.
Use the diesel oil to clean the hexangular shaft (FIG24)
and use the machine oil to lubricate.
Use the diesel oil to clean the turntable claw and guide
rail and use the lithium base grease to lubricate.
(FIG25)
Periodically check the lubrication oil level in the oil fog
device. If the oil level lower than the oil scale, please
feed in the SAE30 lubrication oil in time（FIG 26）
Drain out the water and impurity in the oil water
separator one time every day.
Periodically check and adjust the tension of the driven
belt. Properly adjust the adjust nut in A and B to realize
the
proper tension.（FIG27）。
Check all the connect parts and tight the loosen bolt.
FIG 24
FIG 25
HEXANGULAR SHAFT & LOCK PLA TE
LOCK GAP ADJUSTMENT
When press downward the hexangular lock handle, the