Installation Guide

rotation pedal （ FIG2-11 ） to rotate the turntable

clockwise until the entire lip completely detached. If

handling the tube tire, to avoid the damage on the tube,

you should keep the nozzle of the tire 10cm from the

right side of the demount tool when demounting. If the

demount of the tire is jammed, please stop the machine

immediately and then lift up the pedal to let the

turntable rotate counterclockwise to remove the

resistance！

4.1.5 When handling the tube tire, Take out the tube

and then move the lower lip upwards to the upper edge

of the rim and then repeat the above steps to detach

the other lip .In the process of demounting tire, you

should keep your hands and the other parts of your

body from the movable parts. Necklace, bracelet and

the loose clothing can injury personnel！

4.2 MOUNT TIRE：

Before mount tire, check if the tire and rim are of the

same dimension！

4.2.1 Clean the dirt and rust on the rim and lock it on

the chuck.

4.2.2 Spread the lubrication liquid or soap liquid around

the lip. Tilt the tire against the rim and keep the front

end upwards. Press down the hexangular shaft to

move the demount arm to contact with the rim and lock.

The left lip above the tail of the demount tool and the

right lip will be positioned under the front end of the

demount tool (FIG 21)，Clockwise rotate the turntable to

guide the bottom lip into the tire detaching slot.

FIG 21

4.2.3If there is tube, place it in the tire and plug the core.

And assemble the lip according to the above mentioned

step(FIG22). In the process of clamping the rim, do not

reach your hands in between the rim and the claw to

avoid the damage to the personnel.

FIG 22

FIG 23

4.3 INFLATION：

When inflating the tire, please be carefully and series

obey the operation process. Check the air route to see

if the air connection is OK. This machine is equipped

with an inflation gauge for monitoring the inflation of the

tire and the inflation pressure（FIG2-23）.

1. Loose the tire from the turntable.

2. Connect the inflation hose with the tire air core. See

FIG23.