Installation Guide

9
FIG 10
3.3 AIR SOURCE INSTALLATION：
Air source has been adjusted before ex-factory. If it
needs change, adjust again
3.3.1 Take out the air source and 2 screws from the
accessory boxes and remove the oil and dust. Fix the
screw on the right side of the body（FIG12）
FIG 11
FIG 12
FIG12
3.3.2 Connect air hose: Remove the connect of on the
ø8 PU hose on the lateral side of the body. This
connect is equipped for avoid the air hose from sliding
into the body. And plug into the elbow. See FIG14.
FIG 13
3.3.3 Connect the inflation gun: Plug the inflation gun
connect into the slot of the open nut（FIG15）and tight
the open nut and then connect air supply.
3.3.4 Air source has been adjusted before ex-factory. If
it needs change, adjust again：
Pressure: Lift up the pressure adjustable
button( FIG16-1 ） and twist clockwise and the air
pressure will increase. Meanwhile, if counterclockwise,
the air pressure will decrease.
Oil Feed：Use screw driver to twist the screw（FIG16-2）.
If clockwise, the oil dropping speed will slow. If
counterclockwise,
it will become fast.
FIG 15