Installation Guide

Aug. 2019

SP-6K-SS

STEP 5

Position the two lift arms to the lifting frame (Fig.9 A). In order to make the runway platforms horizontal while

car is loaded, install the arms as follows:

First, lift up the far end of the arms with hydraulic jack to 3-15/16” (100mm) (Fig.9 B & C). Then tighten the

back side two screws and front one screw (Fig.9 D & E). Use the lock-nut to secure adjustments.

A B C

D E F G

Fig. 9

A, B, C, D, E, F, G (Setting-Up Arms)

STEP 6

Install the runways on the lifting arms. If they are hard to move, you can use a chain and a fence-stretcher to

help maneuver them. Position the runway platforms according to the fixing holes on the arms. Bolt the runways

to the lifting arms with the provided bolts. (Fig.10 A, B, C)

Fig. 10

A, B, C (Runway Attachment To Arms)