Installation Guide

SC-2K

Apr 2018

IMPORTANT!

The major piece of the lift is the column assembly. It consists of the carriage, hydraulic cylinder, chain

hydraulic hose and safety latch release cable already pre-assembled. The column assembly will

have a bracket on the side, which will be used for installing the power unit later. The cylinder in the

column may appear to be loose in the column, this is normal. After installation, when the platform is

raised under power, the cylinder should stabilize itself in an upright plumb position.

STEP 1

Carefully remove the shipping brackets. There is one bracket bolted to the underside of the column

(Figs. 3, 4, 5) and another bracket bolted to the side of the column (Figs. 6, 7, 8).

Fig. 3 Fig. 4 Fig. 5

Fig. 6 Fig. 7 Fig. 8

NOTE: If the base of the cylinder is not properly located in the center hole of the column’s

baseplate, it will be required to position it into the base plate hole before lifting the column

upright (Figs.9 & 10). If required, ensure to slide the carriage to base of the column, while

pulling the lock-release cable at the same time (Fig.11).

Fig. 9 Fig. 10 Fig. 11