Installation Guide

SC-2K

Apr 2018

REQUIRED TOOLS

The installation of this lift is relatively simple and can typically be accomplished by 2 men in a

few hours. The following tools and equipment are needed or recommended.

• Fork Lift and/or Engine Hoist for moving pieces & positioning lift column, is recommended.

(You will also need a ten-foot length of 3/8” chain.)

• Rotary Hammer Drill with 3/4” Masonry Drill Bit. (Core Drill Rebar Cutter recommended)

• 6 quarts of Non-Detergent / Non-Foaming Hydraulic Oil - SAE-10, AW 32 or equivalent

• 1” and 5/16” Wrench & Socket with Ratchet

• 1” and 1/8” Socket & Extension

• 1/2” Wrench

• 11/16” Wrench

• Adjustable Wrench

• Small Crowbar or large Screwdriver for aligning bolt holes

• Pliers

• Flat Blade Screwdriver

• Tin Snips

• Gloves

GENERAL INFORMATION

1. Carefully remove the crating and packing materials.

CAUTION! Be careful when cutting steel banding material as items may become loose

and fall causing personal harm or injury.

2. Identify the components and check for damage or shortages.

Please contact your distributor immediately, if any damages or shortages are

discovered.

PACKAGING

• The SC-2K lift assembly is packaged & shipped as two large pieces - Column & Platform

assemblies.

• The SC-2K column comes with cylinder, carriage & chain with the hardware box located

inside the column.

• The SC-2K platform comes with frame and aluminum decking.

• The electric-hydraulic power unit is packaged separately and banded to top of platform.