Installation Guide

3
SC-2K
Apr 2018
IMPORTANT NOTES
READ THE INSTALLATION AND OPERATION MANUAL IN ITS ENTIRETY BEFORE
ATTEMPTING TO INSTALL THE LIFT.
• Do not install this lift on any surface other than concrete, conforming to minimum specifications.
• Do not install this lift over expansion joints or cracks. Check with building architect.
• Do not install this lift on a second floor with a basement beneath without written authorization from
building architect.
• Do not install this lift outdoors unless special consideration has been made to protect the power unit
from inclement weather conditions.
• A level floor is recommended for proper installation and operation. Concrete should be a minimum
of 4-1/4” thickness and 3,000 psi tensile strength with steal or fiber mesh reinforcement.
• The lift is intended to raise the entire body of the vehicle. Do not attempt to lift only part of the vehicle.
Improper use of this equipment could result in damage to the lift, yourself or other property.
• The lift is intended to lift vehicles only. It is not designed to lift any person or equipment containing
persons.
• Users of this equipment should be qualified, responsible and should follow the operation and safety
guidelines set forth in this manual.
• For specifications on concrete pads, please call for technical assistance.
• Improper installation can cause damage or injury. The Manufacturer will NOT assume liability for loss
or damage of any kind, expressed or implied, resulting from improper installation or use of this
product.
DEFINITION
Surface Mounted, Single-Post Lift w/ Hydraulic ‘chain-over’ Drive, 2,000 lbs. capacity.
The name / model number is designated below:
• Model Number: SC-2K - Single Column Platform Storage Lift
(Note: Removable Aluminum Decking is not designed to be load bearing)
SITE PREPARATION
Make sure you have made all necessary measurements to assure that your lift will fit in your
shop / garage and accommodate the type of vehicle you intend to lift with it. Make sure you
have enough clearance at the top, and enough width to allow walking around. Also, be aware
that the electrical power supply requirements are 115 volt, 1 Phase, 20 amps.