Product Manual
5
RJ-45
July 2017
OPERATING INSTRUCTIONS
WARNING!!!
To avoid personal injury and/or property damage, permit only trained personnel to operate jack.
After reviewing these instructions, get familiar with jack controls by running the jack through a
few cycles before loading vehicle on jack. Observe and avoid any pinch point areas of the
linkage mechanism.
1. Before loading a vehicle onto lift, ensure jack(s) are fully lowered. Make sure the adapters
are in their most inbound and lowest position. Also ensure the jack(s) (are) pushed toward
the center of lift before driving vehicle on or off lift. This will provide maximum vehicle
clearance when loading and unloading vehicles.
CAUTION! Always fully lower jack(s) to prevent damage to the vehicle on lift.
2. After vehicle has been loaded, chock tires on the opposite side in which the rolling jack is to
be used. If two rolling jacks are to be used, chock the tires on the opposite side of the
rolling jack to be raised first.
WARNING! Engage runway locks before raising vehicle on jacks!
DO NOT operate lift while jack(s) are engaged with a vehicle!
3. Place jack under vehicle at manufacturer’s recommended pick-up points. Pull out the arms
to the proper pick-up points. Take up clearance with contact pads & height extensions.
CAUTION! Allow 12” minimum clearance between vehicle and nearest overhead
obstruction before raising vehicle above runways. Failure to comply could
damage vehicle and/or cause personal injury.
4. To Raise Rolling Jack: (Ensure the release valve knob is rotated to be fully closed.)
Depress the pump lever repeatedly until the jack is raised to the desired lock position,
followed by turning the hydraulic release valve knob counter-clockwise to lower jack onto
locks.
5. To Lower Rolling Jack: Slightly raise jack to release off locks, followed by moving the
lock release lever to the right, while carefully turning the hydraulic release valve knob
counter-clockwise until the jack lowers completely.
CAUTION! Always fully lower jack to prevent damage to the vehicle or lift.