Full Product Manual

14
MR6.5K-38
Feb 2020
Caster Assembly Installation & Operation for Lift Portability (Optional)
1. Position Lift to the lowest position.
2. Remove Vehicle from Lift.
3. Raise Lift to approx. 20” (500mm).
4. Install the Caster Assemblies towards the inside of lift frame, as shown below.
a. Place Fixed Casters (2) to the mount bars welded to lift frame.
b. Place Swivel Caster (1) to the single welded mount bar welded to opposite side of lift frame.
5. Lower Lift to the lowest position. Simultaneously, the lift will raise onto the Caster Assemblies allowing
for lift portability.
6. Use the Pull / Tow Bar to maneuver the lift into position.
7. Remove the Pull / Tow Bar & Caster Assemblies once the lift is placed in the new location.
Ensure to Maneuver & Position lift on a Dry and Level Surface meeting the Site & Surface
Lift requirements noted on Page 6.
‘Fixed’ Casters Positions
‘Swivel’ Caster Position
Pull / Tow Bar