Full Product Manual

10
MR6.5K-38
Feb 2020
Starting Up / Testing
A. Push the ‘start button’ on the motor pump to prime the hydraulic oil into the cylinders on the lift.
The lift will rise with lock latches passing over the lock ladders (Fig. 8).
B. Release the start button to stop the lift from rising. Press down on the ‘lowering valve lever’ and
the lift will lower down and automatically to engage the next lower lock height (Fig. 8).
Fig. 8
C. Push the ‘start button’ just 2-3 seconds to slightly raise the frame. The safety latches will
disengage from the lock ladder notches.
D. While pressing down & holding the air lock ‘release knob’, also press down on the power unit’s
‘lowering valve lever’ to lower the lift down to the ground.
Final Adjustment
1. If any problems are encountered, do not proceed with subsequent steps. Instead, resolve the problem
before proceeding by referencing the troubleshooting portion of the Owner’s Manual section of this
manual.
2. Raise the lift empty to the top of its travel and lower it to the floor three (3) times to remove the
remaining air from the hydraulic system.
3. The latches should click together as the lift is being raised.
4. After cycling the lift (3) times, check for any hydraulic and/or air leakages. Tighten connections as
required.
5. Ensure to lubricate all sliding components with heavy duty white lithium bearing grease.