Installation Instructions

Step 5

Step 6 (Assemble and Insert Sink Fasteners)

Step 7 (Engage and Tighten Fasteners)

Step 8 (Connect Faucet Supplies and Drain Fittings)

Apply a small bead of silicone caulk compound completely around all edges of

sink opening, Stay approximately 1/4" from cut-out, Use only a 1/8" to 1/4"

bead of silicone.

Note: Using too much sealant may keep the sink from properly sealing to the

countertop.

Assemble the screws into the U channel fasteners as shown (1). The screws are

designed to insert into the channel fasteners with backward threading, so during

mounting they will turn in a counterclockwise direction. Position the fasteners as

shown (2). Slide the U channel fasteners into the channel bar from either open

end and/or slots in the channel. Hand tighten each fastener onto the channel so

that the clamp teeth point toward the U channel.

Insert the sink into the countertop. (If

the cut-out is undersized, please go back

to step 3 and do not force the sink.)

Position the fasteners claw end under top

edge (See diagram (1) for example).

Locate the fastener in the position as

shown in diagram (2).

CAUTION: Improper tightening of channel

fasteners could result in improper

installation or cause damage to sink.

Tightening Sequence is as follows:

A. With U channel fasteners equally

spaced, and with one at each end of

channel bar, hand tighten channel

fasteners, starting at center and

working toward sides.

B. Re-check sink position on counter top.

C. Tighten all channel fasteners an

additional quarter turn with a ﬂat head

screwdriver, Important - DO NOT

OVERTIGHTEN.

Use Teﬂon tape at all threaded water connections to avoid leaks. Connect the

drain trap ﬁttings. Connect the water supply valves to the faucet. Turn on the

water supply valves and check for leaks at all threaded water connections.

Fill the sink bowl with water and check around the drain ﬂange(s) for moisture

and for water dripping onto the bottom of the cabinet.

Release water from sink and tighten any leaky connections found.

Step 5

Step 6

Step 8

and