Installation Instructions

Retrofit Apron Front Farm Sink

With Dual Mount Capability

Retrofit Apron Front Farm Sink

With Dual Mount Capability

Installation Instructions

For Top-Mount Use Only

-7-

- To protect the cabinet finish, temporarily apply

painter's tape around the cabinet cutout.

- Apply a bead of silicone around the cutout.

- Carefully lower the sink into the cabinet.

- Be sure to wipe away any excess silicone sealant.

5. Install the Sink

- Slide three clips into either side of the back rail of the sink.

- Slide two clips into each side rail of the sink.

- Evenly space the clips.

- Assemble the screws into the U channel fasteners as shown.

6. Install the clips from under the cabinet.

NOTE: Screws are designed to insert into the channel

fasteners with backward threading, so that when mounting

they will turn in a counter-clockwise direction.

-Locate the fasteners in the position as shown.

- Hand tighten each fastener onto the channel so that the clamp

“teeth” point in the same direction as the U channel. To install

U channel fasteners in channel bar: Slide U channel fasteners

in channel bar from either open end and /or slots in channel.

Place U channel fasteners equally spaced and with one

at each end of channel bar, hand tighten channel fasteners,

starting at the center and working toward sides.

Position the fasteners claw under the top edge as shown.

Locate the fastener in position as shown.

Caution: Improper tightening of channel fasteners could

result in improper installation or cause damage to sink.

Re-check sinks position on countertop.

Tighten all channel fasteners an additional quarter turn

with a flat head screwdriver.

Tool

IMPORTANT! DO NOT OVERTIGHTEN.

Have a question? DON'T GO BACK TO THE STORE, WE CAN HELP, just call 1-800-626-3525, 8 a.m. to 5 p.m. EST Monday-Friday,

or send an email to Help@cmiproduct.com.