Installation Instructions

Retrofit Apron Front Farm Sink
With Dual Mount Capability
Installation Instructions
Retrofit Apron Front Farm Sink
With Dual Mount Capability
Installation Instructions
For Top-Mount Use Only
- 12-
Tool
6. Install the Sink
- To protect the cabinet finish, temporarily put painter's tape
around the cabinet cutout.
- Apply a bead of silicone around the cutout.
- Carefully lower the sink into the cabinet.
Be sure to wipe away any excess silicone sealant.-
7. Install the clips from under the cabinet
- Slide three clips into either side of the back rail of the sink.
- Slide two clips into each side rail of the sink.
- Evenly space the clips.
- Assemble the screws into the U channel fasteners as shown.
Screws are designed to insert into the channel
fasteners with backward threading, so that when mounting
they will turn in a counter-clockwise direction.
NOTE:
-
-
Position the fasteners claw under the top edge as shown.
Locate the fastener in position as shown.
CAUTION: Improper tightening of channel
fasteners could result in improper installation
or cause damage to sink.
A. Place U channel fasteners equally spaced and with one at each
end of channel bar, hand tighten channel fasteners, starting at the
center and working toward sides.
B. Re-check sinks position on countertop.
C. Tighten all channel fasteners an additional quarter turn with a
flat head screwdriver.
IMPORTANT! DO NOT OVERTIGHTEN.
Have a question? DON'T GO BACK TO THE STORE, WE CAN HELP, just call 1-800-626-3525, 8 a.m. to 5 p.m. EST Monday-Friday,
or send an email to [e-mail].
Locate the fasteners in the position as shown.
Hand tighten each fastener onto the channel so that the clamp
“teeth” point in the same direction as the U channel. To install
U channel fasteners in channel bar: Slide U channel fasteners
in channel bar from either open end and /or slots in channel.