Installation Instructions

Retrofit Apron Front Farm Sink
With Dual Mount Capability
Installation Instructions
Retrofit Apron Front Farm Sink
With Dual Mount Capability
Installation Instructions
For Top-Mount Use Only
-11-
5. Cut the Countertop
IMPORTANT! To avoid damage to the cabinet
surfaces, cut the countertop in the order of the
steps below.
To prevent chipping the laminate, put painter's
tape to the edge of the countertop before cutting.
TIP:
TIP: Make sure your equipment is in good
working order and your blades are sharp
to ensure a smooth installation and
straight cuts.
1. Cut inside line
Do not cut beyond marked line!
2. Cut away from cutout, flush with cabinet face.
3. Cut to intersect
with previous cut.
Please use sand paper to smooth all cut edges.TIP:
- Lower the sink carefully into the countertop opening to make
sure it fits, do not force it. The fit will be tight. If the opening is
too small please recheck your dimensions.
1. Using the laminate saw blade cut the countertop along
the inside marked line.
2. Carefully cut away from the cutout to the marked notch
line. Be careful not to damage the cabinet face.
Repeat this step on the other side.
3. Carefully cut in from the edge of the countertop to
intersect with the previous cut. Be careful not to damage
the cabinet face.
Repeat this step on the other side.
4. Very Important - Spread a generous amount of waterproof
wood glue on both notches to seal the newly exposed wood.
This will help to make this area water resistant and keep
water from penetrating into the wood and swelling the
underlayment. Please wipe away any excess glue.
Please wipe away any excess glue.
Please allow the wood glue to dry completely.
TIP:
Have a question? DON'T GO BACK TO THE STORE, WE CAN HELP, just call 1-800-626-3525, 8 a.m. to 5 p.m. EST Monday-Friday,
or send an email to [e-mail].