Installation Instructions

INSTALLATION INSTRUCTIONS
GRANITE CARE & MAINTENANCE
Step 1
 Vanity Prep: Ensure that the vanity on which the
top is to be placed is level and properly secured to
the wall. Your granite vanity top is heavy natural
stone, which requires solid support. If the vanity is
of a “frameless” design, it is recommended that
additional support be added. Additional wood
support should be 1”x1” wood sections that run
along the top inside edge of the sides and front of the
vanity. The wood sections should be affixed to the
vanity using construction adhesive and wood screws
that do not protrude through any exposed sides.
Step 2
 Top Installation: Apply a thin bead of 100%
silicone sealer on the cabinet-top edges. Place the
vanity top on the vanity with an overhang of ½” on
the left and right edges. Allow the sealer to dry per
the manufacturer’s instructions.
Step 3
 Backsplash and Side-Splash Installation: Be sure
the wall is clean, dry and smooth. Repair any holes
or uneven sections using a patching compound.
Remove loose paint, any wallpaper or decorative
material. Apply two beads of caulking or
construction adhesive on the rear of the backsplash
(and side-splash if required) and push firmly onto
the wall.
Step 4
 Faucet and Drain Assembly Installation: Install
the faucet and drain assembly per the
manufacturer’s instructions. DO NOT tighten the
drain pipe connection to the bottom of the bowl
with a wrench as it may result in damage to the
bowl. Tighten only by hand.
Your new natural granite vanity top has been factory
polished to a smooth finish and has had the initial
protective sealant applied. In order to properly maintain the
surface, the following procedures are recommended:
 Reseal your vanity top no less than one time per
year. Before applying the sealer, all exposed areas
should be completely clean and dry. A high quality
granite sealer is available for purchase at your local
Menards store. Follow the instructions on the sealer
container.
 For routine maintenance and cleaning, you may
wipe-off and clean your vanity top with soap and
water. Once per week, or as needed with heavier
use, use a stone spray cleaner or polish; either of
which are available from your local Menard’s store.
Follow the instructions on the granite cleaner or
polish container.
 Place protective pads on the bottoms of any heavy
objects such as pottery, vases, appliances or other
objects that may scratch the granite surface.
 Liquid spills, such as alcohol, medications, etc.,
should be cleaned promptly. Some liquids with
high-acid content can etch the granite surfaces if
left for any length of time. Common products that
should be promptly cleaned are: shaving cream,
toothpaste, perfume, cologne, nail polish remover,
hair coloring or perm products, shampoo, drain
opener and toilet bowl cleaner.
 Avoid using abrasive cleaners or rough cleaning pads.
If necessary, a soft buffing pad can be used to remove
stubborn materials that may have become affixed to
the top.
 Use coasters under drinking glasses to prevent glass
rings on the surface.
 Do not stand or place extremely heavy objects on the
top.
If you have any questions or comments please contact
Tuscany Granite Vanity Tops Customer Service:
(253-813-5692) or [e-mail]