Tools Needed For Models ; 6736249 Adjustable Wrench N Groove Joint Puller Q Phillips Screwdriver « Silicone Sealant Teflon Tape Included ¢ VICTORIA Double Handle Deck or Wall Maintenance Mount Bath Faucet with Your new faucet Is designed for years of trouble-free HO nd_He|d Shower performance. Keep It looking new by cleaning It periodically with a soft, damp cloth. Av old abrasive cleaners, steel wool and harsh chemicals as these will dull the finish and void your warranty.
Parts Diagram / List No.| Part Name Handle Button Screw Washer Handle Trim Cap Adapter Cartridge [Hot] @ Washer Shower Shower Holder Washer Check Valve Connector 21 14 | Button 24 | Nut 25 | Washer Screw Handle Adapter Lock Nut Diverted Body Lock Nut Wall Base \) 23 | O-inf 24 | supplementary Nipple 27 | O-ring Spout 29 | Aerator Washer Aerator Core Aerator Color Deck Mount Feet Trim Cap Wearing Ring ™31 35 | Washer 40 36 | Lock Nut! 37 | Shower Hose 38 | Washer 39 | Cartridge (Cold) 40 | Aerator Assembly H
Preparation/Assembly 1. Shut off the water supplies before Installation. Remove the current faucet. Clean and dry the surface the new faucet well be Installed on. 2. Wall Mount Installation: Apply Teflon tape to the threads of the offset water supply nipple Screw the offset water supply nipple (#26) to the embedded outlet pipe. Slide the washer then the wall base (#22) onto the offset water supply nipple making sure the wall base (#22) is flush against the wall.
Installation Instructions 5. Screw 42" flexible stainless steel supply lines (sold separately) onto the bottom of the deck mount feet 6. Apply Teflon tape onto the threads of the faucet water shut offs In a clockwise direction. Tighten the water supply lines onto the water supply shut offs. Be sure o connect the cold water supply line to the cold water shut off (typically on the right) and the hot water supply line to the hot water shut off (typically on the left). 7.
Troubleshooting If you've followed the Instructions carefully and your faucet still does not work properly, take these corrective steps. Problem Cause Acton Remove the handle (#4) and trim cap Tighten or replace the cartridge (#7 or #39). Remove the handle fim cap (#5) and cartridge (#7 or #39). Check the ceramic deskill for dirt and damage. If the cartridge Is dirty, soak It In warm white vinegar for 4 hours.
