Installation Instructions

ManualsBrandsTuscany ManualsBathGatineau Two-Handle 4" Centerset Polished Chrome Bathroom Faucet

Table Of Contents

Summary of content (6 pages)

PAGE 1
Tools Needed Adjustable Wrench $ w, + Groove Joint Slier W. SR Phillips Screwdriver X, hN Silicone Sealant NE + Teflon Tape La ) Maintenance Your new faucet is designed for years of trouble-free performance. Keep it looking new by cleaning it periodically with a doff, damp cloth. Avoid abrasive cleaners, steel wool and harsh chemicals as these will dull the finish and cold your warranty.
PAGE 2
Parts Diagram / List 16 Part Name Handle Wearing Ring Handle Body Set Screw Wearing Ring Adapter Screw Lock Nut Washer Deck Plate Cartridge (Hot) 12 | O-ring 13 | Under body 14 | Gasket 15 | Lock Nut 16 | Spout 17 | Aerator 18 | Cartridge (Cold) 19 |Screw 20 | Allen Wrench 21 | Aerator Wrench 22 |Cover 23 | Washer 24 | Stopper Core 25 | Stopper Housing 26 |Small Washer 27 | Large Washer 28 | Lock Nut 2% |Handle Assembly Have a question? DON'T GO BACK TO THE STORE, WE CAN HELP, just call 1-800-626-3525 ,8 a.
PAGE 3
Preparation/Assembly 1. Shut off the water supplies before installation. Remove the current faucet. Clean and dry the surface the new faucet will be installed on. 2. Unscrew the lock nuts (#15) from the under body (#1 3). Note: Do not remove the customer service tag with the model number and phone number. This information will be needed when calling the customer service department. 3. Place silicone sealant beneath the gasket (#14) and insert the under body (#13) through the faucet [7 holes.
PAGE 4
Installation Instructions 7. Apply Teflon tape onto the threads of the faucet water shut offs in a clockwise direction. Tighten the water supply hoses onto the water supply shut offs. Be sure to connect the cold water supply hose to the cold water shut off (typically on the right) and the hot water supply hose to the hot water shut off (typically on the left). 8. Remove the lock nut large washer and small washer (#26) from the drain assembly.
PAGE 5
Installation Instructions 12. Use the aerator wrench (#21) to remove the aerator Open the hot and cold shut offs and check for leaks. If a leak occurs, refer to 7a step b6or7. aE Note: Do NOT use pliers to remove the aerator (#17) as this may cause damage. Use the aerator wrench (#21) provided. 13. Close the drain and fill the sink with water. Check for leaks. If water is leaking from the drain, refer to stepsister. 14. Turn on both the hot and cold water and let it run for one minute.
PAGE 6
Troubleshooting If you've followed the Instructions carefully and your faucet still does not work properly, take these corrective steps. Problem Cause Action Turn the water supplies off, Turn on the hot and cold handle assembly (#29) to release the pressure, then close the handle assembly Remove the set screw and handle Leaks underneath the The lock nut (#8} has come | @assembly If the lock nut (#8) is loose tighten it.