Tools Adjustable Wrench (2) Teflon Tape Groove Joint Slier « Phillips Screwdriver Silicone Sealant Maintenance Your new faucet Is designed for years of trouble-free performance. Keep it looking new by cleaning it periodically with a soft, damp cloth. Av old abrasive cleaners, steel wool and harsh chemicals as these will dull the finish and cold your warranty. Safety Tips + If you use soldering for the Installation of the faucet, the seats, cartridges and washers will have to be removed before using flame.
Parts Diagram / List Part Name 1 Handle Button 2 Set Screw 3 Handle 4 Trim Cap S Lock Nut [3 Ceramic Cartridge 7 Cartridge Seat 8 Set Screw 9 O-ring 10 | Aerator Washer 1 Aerator Core 12 | Aerator Collar 13 Body 14 Q-ring 15 Copper Tube 14 Copper Tube 17 | Shank 18 Gasket Assembly 19 Lockout 20 | Screw 21 Cover 22 | Stoppers 23 | StopperHousing{Without Overflow Hole) 24 | stopper Housing{With Overflow Hole) 25 Washer 26 | Washer 27 Wearing Ring 28 Lock Nut 29 O-ring 30 Outlet Pipe 31 Nut 32 Aerator Assembly
Preparation/Assembly 1. Shut off the water supplies before installation. Remove the current faucet, clean and dry the sink surface the new faucet will be installed on. 2. Unscrew the lock nut (#19) and gasket assembly Please Note: Do not remove the customer service tag with the model umber and phone number as this will be helpful if you need assistance in the future. 3. Apply Teflon tape on threads of the faucet cold & hot water supply tubes in a clockwise direction. 4.
Installation Instructions 5. Slip 1/2” coupling nuts onto water supply tubes or use flexible stainless steel supply lines (recommended) — both are sold separately. To <& avoid breaking the copper tube on the faucet, use two wrenches (as shown) to keep from twisting the supply tube from the faucet when you tighten the nut. Typically the cold water supply is on the 3 right and the hot water supply is on the left. Water Subtly Hoses 6.
Installation Instructions Install washer (#26) and wearing ring (#27) to the stopper housing (#23 or then hand tighten the lock nut but do not over tighten. See diagram for visual. 2 Position o-ring (#29) into outlet pipe attach nut (#31) onto outlet pipe and then hand tighten nut but do not over tighten. See diagram for visual. Hint outlet pipe (#30) is used to connect to the p-trap drain please refer to those installation 2 t instruction for assembly.
Trouble-Shooting It you've followed the instructions carefully and your faucet still does not work properly, take these corrective steps. Problem Cause Action Leaks underneath handle. Lock nut (#5) has come loose. Tighten the lock nut Remove handle (#3) and cartridge (#6) to check if ceramic disk is damaged permanently or dirty. Re-Install the cartridge (#6) or Water will not shut off completely.
