instruction manual 2 YEARGUARANTEE AP-T10-GB
READ ALL INSTRUCTIONS BEFORE USE. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. • ALWAYS unplug the appliance from the electrical outlet immediately after using and before cleaning. To disconnect, turn all controls to the ‘OFF’ position, then remove plug from outlet. • Unplug from the mains outlet when not in use and before putting on or taking off parts or attachments.
• Do not run cord under carpeting. Do not cover cord with throw rugs, runners or similar coverings. Do not route cord under furniture or appliances. Arrange cord away from traffic areas where it can be tripped over. TWO YEAR GUARANTEE FKA Brands Ltd guarantees this product from defect in material and workmanship for a period of 2 years from the date of purchase, except as noted below.
PRODUCT FEATURES CONTROL PANEL POWER IONISER ON/OFF FAN SPEED NIGHTLIGHT ALL-IN-ONE HEPA-TYPE FILTER OIL TRAY FILTER COVER ALL-IN-ONE HEPA-TYPE FILTRATION SYSTEM HEPA-TYPE FILTRATION Removes up to 99% of airborne particles as small as 0.3 microns, such as allergens, pollen, dust, germs, pet dander, odour, mould spores, and smoke from air that passes through the filter.
OPERATING INSTRUCTIONS BEFORE TURNING THE UNIT ON • Take the air purifier out of the box and remove the clear protective plastic bag. • Place the air purifier on a firm, level surface. • Plug the power cord into a standard AC outlet. POWER BUTTON AND FAN SPEED SETTINGS • To turn the air purifier on, press the power button. • This air purifier has 2 fan speed settings: low and high. The higher the fan speed setting, the faster the air will be purified.
FILTER REPLACEMENT CLEANING & MAINTENANCE REPLACE FILTER LIGHT The replace filter light illuminates when it is time to replace the HEPA-type filter based on the air purifier’s hours of use. CLEANING THE PRE-FILTER NOTE: For best performance, vacuum the pre-filter once a month under normal usage. 1. Unplug the air purifier. 2. Remove the HEPA-type filter as described in the Replacing the HEPA-type Filter section. 3.
TROUBLESHOOTING PROBLEM POSSIBLE CAUSE Unit will not operate • • • • • Unit is not plugged in Power button not pressed No power to unit HEPA-type filter is not installed correctly Grille cover is not installed correctly Reduced airflow • The back grille may be blocked SOLUTION • • • • • Plug unit in Press the power button to turn the power on Check fuses, try a different outlet Reinstall the HEPA-type filter Reinstall the grille cover • The HEPA-type filter needs to be replaced • Check to make sur
Distributor in Australia: HoMedics Australia Pty Ltd, 14 Kingsley Close, Rowville, VIC 3178, Australia IB-APT10GB-1220-01
