Daim Ntawv Qhia Tus Neeg Siv
1.Turn off and un-plug equipment to be protected from wall outlet.
2. Plug the equipment into the Guardian unit.
3. Plug the Guardian unit into grounded wall outlet.
4. Your equipment is now fully protected. Place the Guardian where monitoring lights
can be observed.
Installation of TBF™
Guardian
Power Cord
Installation for Protection for Telephone Line and Network Cable
Installation for Protection for Network Cable
TELEPHONE
1. Unplug the equipment's telephone cable from the wall jack and plug into the RJ11 "DEVICE"
on the Guardian.
2. Plug the provided telephone cable to the RJ11 jack "LINE" on the Guardian.
3. Plug the other end of the telephone cable into the RJ11 wall jack.
CAUTION: - Never install telephone wiring during a lightning storm.
- Disconnect telephone line at the network interface before installing the secondary
protector.
- Intended for indoor use only.
Use the Standard CAT 5 Network Patch cord when using the Network protection RJ45 circuit.
Connected
Equipment with
Tel./Modem Jack
Power Cord
Power Cord
Phone Cord
Phone Cord
Network Cord
Network Cord
LINE
LINE
DEVICE
DEVICE
Phone
Wall Jack
Network Jack/ HUB
Connected
Equipment with
Network Jack
IMPORTANT: The Guardian is designed to be compatible with a GFCI (Ground Fault Circuit Interrupter), however,
during plug in the GFCI might trip. Press the reset button to restart the circuit.
Note: Do Not plug more than 3 Guardian products to a circuit that has a GFCI circuit breaker or GFCI wall outlets.
The GREEN light confirms properly the connected equipment is
fully protected. The RED light indicates over voltage, improper
ground connection or reversed power wires which needs to be
corrected. In an over voltage incident, power is disconnected to
protect the connected equipment.
IMPORTANT: If the RED light comes on, contact your electrician
to inspect and correct the outlet wiring in order to receive the
maximum protection for your connected equipment.
NETWORK
1. Unplug the equipment's network cable from the wall RJ45 network jack and plug into the RJ45
"DEVICE" on the Guardian.
2. Plug the provided CAT5 cable to the RJ45 jack "LINE" on the Guardian.
3. Plug the other end of the CAT5 cable into the wall RJ45 network jack. Your equipment is now
fully protected. Place the Guardian where monitoring lights can be observed.
Telephone Line Protection clamping voltage 250-350 vdc.