Owner's Manual

www.adhguardianusa.com 
Outlet within
6 ft (1.83m)
of garage door
opener
Ceiling
Prepare Your Garage Door
To test your garage door:
1. Raise and lower the door to check it if there is any sticking or binding.
2. Check for loose hinges, damaged rollers, frayed cables, and damaged or broken springs.
3. Lift the door approximately halfway and release. The door should stay at that point
under proper spring tension.
WARNING
This product can expose you to chemicals including lead, that are known to the State of California to cause cancer,
birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
CAUTION
To be compliant with California SB969, this Garage Door Openers must be installed with battery backup kit.
PREPARE for installation
This operator is compatible with the following doors:
- Sectional doors up to 14 feet (4.3 m) high.
- Sectional doors up to 18 feet (5.5 m) wide.
- Doors with 1” diameter torsion bar and torsion springs with 4” to 6” drums.
- Sectional high lift doors (up to 54 inches (137.2 cm) of high lift).
- Doors with 12” or 15” radius tracks.
- It is not compatible with reverse wound drums.
If the Cable Tension Monitor is not required (for example with a sectional high
lift door), to disable the Cable Tension Monitor system, move the jumper to the
right using a pair of needle nose pliers. With the cable tension monitor jumper in
the disabled position, the operator will be able to run without a connected cable
tension monitor. To return to cable tension monitor enabled mode, move the
jumper to the left, connect the cable tension monitor and re-power the opener.
On the side chosen to mount the opener, the proper clearances are:
For California Residents
Between ceiling and torsion
bar must be a distance of 3’’
(7.6cm) or more
Wall
Wall
Torsion
Bar
Enable
Disable
3’’’
(7.6 cm)
2.5’’
(6.4 cm)
1.5”
(3.81 cm)
8.5”
(21.6 cm)
UP
DOWN
LEARN
FORCE
LIMIT
OK
UP
DOWN
CABLE
MONITOR
LOCK
LOCK
PHOTO
EYES
PUSH
BUTTON
WALL
PANEL