Owner's Manual

www.adhguardianusa.com 
OK
X 3
Programming Remote Controls
WARNING
To prevent possible SERIOUS INJURY or DEATH:
- Keep remote control and battery out of reach of children.
- NEVER permit children to access the Deluxe Door Control Console or Remote Controls.
- Operate the door ONLY when it is properly adjusted, and there are no obstructions present.
- ALWAYS keep a moving door in sight until completely closed. NEVER cross the path of a moving
door.
To reduce risk of re, explosion or electric shock:
- DO NOT short circuit, recharge, disassemble or heat the battery.
- Dispose of batteries properly.
To Program Remote Control (s):
1. Press/release the “LEARN” button once on the control panel, “OK” LED will glow and beep. The unit is now ready to
accept a remote control in the next 30 seconds.
2. Press/release any desired button on the Remote Control.
3. The “OK” LED will ash and beep twice indicating Remote Control is stored successfully.
Up to 20 Remote Controls (including wireless keypad codes) can be added to the unit by repeating the above
procedures.
If more than 20 Remote Controls are stored, the rst stored Remote Control will be replaced. (i.e. the 21st Remote
Control replaces the 1st stored Remote Control).
Removing ALL Remote Controls:
To remove ALL Remote Controls from memory, press and hold the “LEARN” button for 3 seconds. The “OK” LED will ash
and beep 3 times indicating ALL Remote Controls have been removed from memory.
Replacing Remote Control Battery:
When the battery of the Remote Control is low, indicator light will become dim and /or the range of the Remote Control
will decrease. To replace the battery, pry open the Remote Control using the visor clip or small screwdriver. Replace with a
CR2032 battery. Snap the housing back together.
This device complies FCC Rules for HOME
OR OFFICE USE. Operation is subject to the
following two conditions: (1) this device
may not cause harmful interference, and
(2) this device must accept any interference
received, including interference that may
cause undesired operation.
Battery
PCB
Coin Cell
Battery Holder