Owner's Manual

www.adhguardianusa.com
Bottom screw
#6 x 1-3/8
Min. 5 feet
(1.5m) above
oor
Top screw
#6 x 1-3/8
U-
Connecting Deluxe Door Control Console
To prevent possible SERIOUS INJURY or DEATH.
- Power MUST NOT be connected until instructed.
To prevent SERIOUS INJURY or DEATH from using the Deluxe Door Control Console and a closing door:
- Install the Deluxe Door Control Console or Push Button within sight of the door at a minimum height of 5
feet (1.5m) above the oor. Make sure it is out of the reach of children and moving parts of door and
hardware.
- NEVER permit children to access the Deluxe Door Control Console, or Remote Controls.
- Operate the door ONLY when it is adjusted properly with no obstructions present and is in clear sight.
- ALWAYS keep a moving door in sight until it’s completely closed.
- NEVER cross the path of a moving door.
The Deluxe Door Control Console is a wired, illuminated door control placed inside your garage.
To install the Deluxe Door Control Console:
1. Connect the plug from the Deluxe Door Control Console to the “Wall Panel” outlet on the control panel of the opener.
Run bell wire to location where console will be mounted.
2. Fasten white wire to U+ terminal. Fasten striped wire to U- terminal.
3. Lift the large actuator cover on door the control console and the upper screw post is exposed. Position the deluxe
door control console at minimum height of 5 feet (1.5m) above the oor to keep out of the reach of children, within sight
of door and free from any moving parts on the door. Mark the position of both upper screw post and lower screw hole on
the deluxe door control console. Fasten the bottom screw to a solid surface with #6 x 1 - 3/8” screws.
If attaching to drywall or other hollow surface, drill 3/16” holes and use the provided drywall anchors. Align the bottom
hole with the bottom screw, slide the door control down into place. Secure the deluxe door control console with the upper
screw. Flip down the actuator cover back into place.
WARNING
U+