User Manual
14
Go to Table of Contents
Pairing the Headset and Transmitter
The Stealth 450 Wireless Transmitter sends audio and chat between your PC and your Headset via
digital radio frequency signal, so a direct line of sight is not required. When the headset and
transmitter are communicating, the Connection Status LED on the Wireless Transmitter will stay lit.
NOTE: Your Stealth 450 Headset ships already paired for communication with your Wireless
Transmitter. In normal operation, it should not be necessary for you to pair the two again. You
should only need to perform pairing yourself in the event that wireless communication fails. First
check that the headset is powered on and is within range. If the Connection Status LED on the
Wireless Transmitter is still pulsing, the Wireless Transmitter can’t communicate with the Headset.
Perform the following pairing procedure.
3. Press and hold the Power Button on the Headset until the headset Charge/Pairing Status LED ashes rapidly and
the Headset announces “Pairing”.
4. Within a few seconds the Connection Status LED on the Transmitter and the power LED on the Headset will turn
Solid. The Headset will also announce “Headset Paired” to conrm that pairing was successful.
2. The Pair Button on the Transmitter is recessed in a pinhole to prevent accidental operation. Insert a paperclip
(or something similar) into the pinhole until the transmitter’s Connection Status LED ashes rapidly.
1. The Headset should be powered OFF. If it’s on, press and hold the Power Button on the right Earcup for ve seconds
to power OFF.