Owner's Manual

5 6
GAME
CHAT
ON MIC MUTE
GAME
CHAT
ON MIC MUTE
GAME
CHAT
ON MIC MUTE
GAME
CHAT
ON MIC MUTE
GAME
CHAT
ON MIC MUTE
GAME
CHAT
ON MIC MUTE
Xbox 360
®
Setup
Console A/V cable or
HDMI Cable
USB Cable
(included)
Optical Cable
(included)
Xbox 360
1. Connect the digital optical cable (included) from the digital output on your Xbox 360 to the digital input on the DSS2.
(
NOTE: Remove the protective caps from each end of the optical cable before inserting into the sockets.)
2. Connect the DSS2 USB power cable from the power socket on the rear of the DSS2 to a free USB port on your Xbox 360.
3. Slide the DSS2 power switch to the ON position. The Power LED on the DSS2 will turn ON.
4. Insert the green 3.5mm connector from the headset to the Headphone Output Jack on the front of the DSS2. Then insert the USB
connector from the headset to the USB Output on the DSS2.
5. Adjust the Volume Control knob to adjust the overall volume level of the Headset Output.
1
2
3
4
5
OR
Current Setting
Dolby Digital
Choose the digital output
type for your system.
This setting only applies
to optical digital and HDMI
audio outputs.
Digital Stereo
Select Back
Digital Output
Dolby Digital 5.1
Dolby Digital 5.1 with WMA Pro
1. In the Xbox 360 System Settings, select:
Settings > Audio > Accessory Settings > Audio Device Settings
Set the “Digital Output” to “Dolby Digital 5.1”
2. Settings > Preferences > Voice
Set the “Voice/Game Volume” to 10 and set the
“Voice Output” to “Play Through Headset”
NOTE: Older Xbox 360 models require an Xbox 360 HDMI
Audio Adapter Cable for optical audio output (sold separately).
If your HDTV has an optical AUDIO OUT jack, you can use it
to connect the optical cable to the DSS2 and feed sound from
the gaming console to the DSS2.
Xbox 360
HDMI
Audio
Adapter
Xbox 360
Input
Xbox 360
Talkback Cable
Xbox 360
Controller
Xbox 360 Chat Setup
Configure Xbox 360 Settings
Voice Volume 10
Voice
Mute Kinect
Voice Output
Play Through Headset
Play Through Speakers
Voice Output
Game Volume 10
Chat
Volume
Mic
Mute