User Manual

AdjustIt 3 - Wall Mount 2
4
Use two screws and two M8 washers to attach the handle to the central structure.
5
Mount the appropriate board:
DualBoard
a
Place the DualBoard over the center lip.
b
Use two screws and two M6 washers to attach the DualBoard brakes from the central structure to the top of
the board.
Touch Board
a
Attach the Touch Board brakes to the board.
NOTE
For 78 in. boards, place the brakes facing up. For 88 in. boards, place the brakes facing
down.
b
Place the Touch Board on the board shelf.
c
Attach the brakes to the central structure.
6
Push the board shelf back to secure the board from kicking out.
7
Tighten the board shelf screws.
8
If necessary, use the handle to adjust the board height. Lift the handle up to raise the board. To lower the board, lift the
handle and push down on the board shelf.
© 2014 Turning Technologies, LLC. All rights reserved.
turningtechnologies.com/user-guides