User Manual

-
2
-
Auto-charge current limit: When charging NiCd or NiMH at 'AUTO' current mode, you can
set the upper limit of change current to avoid from high current charging. This is very useful
when charging the low impedance and small capacity NiMH battery in 'AUTO' mode.
Capacity limit: The changing capacity always calculated by multiple of the charging
current and time. If the charging capacity exceeds the limit the process will be terminated
automatically when you set the maximum value.
Temperature limit: The temperature of the battery on charging will rise by its internal
chemical reaction. If you set the limit of temperature the process will be expired forcibly when
the limit has reached.
Processing time limit: you can also restrain the maximum process time to prevent from
any possible defect.
Input power monitor: To protect the car battery using as input power from being damaged
the voltage of it always monitored. If it dorps below the lower limit the process will be ended
automatically.
Automatic cooling fan: The electric cooling fan comes into action automatically only when
the internal temperature of the unit is raised.
Data store/load
For users convenience it can store maximum 5 data of different batteries. You can
establish the data contains program setting of the battery to charge or discharge continually.
These data can be called out at any time you need and the process can be executed without
program setting.
Cyclic charging/discharging
Perform 1 to 5 cycles of charge>discharge or discharge>charge continually for battery
refreshing and balancing.
* PC based analysis using USB communication
For technical expert, It offers PC based program can analyse the characteristic of the
battery by USB port. It shows a graph of voltage, current, capacity and temperatu re curves. It
also shows the individual voltage of each cell in the Lithium battery pack.