User Manual

6.2 Charging Lithium battery at balance mode

This function is for balancing the voltage of Lithium-polymer battery cells while charging.

In the balance mode, the battery needs to have a balance lead to connect to the battery's

power lead to the output of chaeger.

In this mode, the charging process will be different from ordinary charging mode. The

internal processor of the charger will monitor the voltages of each cell of the battery pack

and controls charging current that is feeding to each cell to normalise the voltage.

he value on the left side of second line sets a charge

current and the value on the right side of second lines

sets the voltage of the battery pack.

After setting the current and voltage press Start/ Enter

key for more than 3 seconds to start the process.

(Charge current:0.1~6.0A, Volatge:3.7~22.2V)

This shows the number of cells you set up and the

processor detects.' R: ' shows the number of cells found

by the charger and ' S:' is the number of cells selected by

you at the previous screen. If both numbers are identical

you can start charging by press Start /Enter button. If

not, press Batt type/Stop button to go back to previous

screen. Then carefully check the number of cells of the

battery pack to charge again.

The screen shows the present situation during charge

process. To stop charging press Batt type/Stop key once.

BALANCE

6.3 'FAST' charging of Lithium battery

The charging current is getting smaller as the process goes to the near end term of

Lithium battery chaging. To nish charging process earlier, this program eliminate certain term

of CV process. Actually, the charging current will goes to 1/5 from the initial value to end the

process while the normal chaging goes to 1/10 during CV term. The charging capacity may

be a bit smaller than normal charging but the process time will be reduced.

The value on the left side of the second lines sets the

charge current. The value on the right side of the second

lines sets the battery pack’s voltage. After setting current

and voltage, press Start/Enter for more than 3 second to

start the process.