User Manual

10.2.4G Operation notes
This is 2.4 G Frequency model products make of automatic address code.It use digital
transmission mode, and this prevent outside interference effective active and passive.
10. 01 Matching (code)
1. Install the battery to 2.4G transmitter and shut it down.
2 . ( 1）。Insert the matching lines to the channel Bat port of the receiver. Figure.
3 . Connect the receiver battery to any one of the channel port, on the same time the
two LED are flashing and this means the receiver are going to the match status.
4 . Press and hold the button on the transmitter, and then switch on the power supply.
6 . Release the match button on the transmitter, take out the match line.
5 .
（ )
Observe the LED on the receiver, if found that the LED is not flash anymore and
that means successful matched. This process about 10s
7 . Install the server and then test.
8 . If the tests fail, please repeat the action above.
9 . If the tests success, then insert the power supply port into BAT, match complete.
(The above ways of match is only suitable on FLYSKY 2.4G products)
Our products are well matched in the factory, you do not need to match by yourself.
But if your are going to match the receiver with other transmitter, please follow the
following steps:
Match line
Match key
Figure 1
10. 02 Boot
1. Connect every part.
2. Switch on the power supply.
3. Connect the power supply.
4. Receive LED light solid.
5. Finish and use.
2. 4G 6 Channel remote system
8
FS-CT6A
Model:
Notes