User Manual

How to Connect 2 of these Regulators using SHOTTKY Diodes

If you look straight to the Shottky (like MBR1545)with the printed side (number and name) towards

you and pins facing to the ground, extreme left is Pin 1, Middle is Pin 2 and extreme right will be Pin

No 3.

1.) Connect the positive from the output of the 1st BEC to Pin 1

2.) Connect the positive from the output of the 2nd BEC to Pin 3

3.) Connect the positive to the RECEIVER from pin 2

4.) Connect all the black (negatives) together.

CHEERS!!!

SAURABH.

PAGE 1
How to Connect 2 of these Regulators using SHOTTKY Diodes If you look straight to the Shottky (like MBR1545)with the printed side (number and name) towards you and pins facing to the ground, extreme left is Pin 1, Middle is Pin 2 and extreme right will be Pin No 3. 1.) Connect the positive from the output of the 1st BEC to Pin 1 2.) Connect the positive from the output of the 2nd BEC to Pin 3 3.) Connect the positive to the RECEIVER from pin 2 4.) Connect all the black (negatives) together.