User Manual

1 .To enter calibration mode press and hold the Enter button until a long beep is
heard and LED 1 is illuminated constantly.
2 .Moving the throttle to the neutral position and a short press of the Enter button
will set the throttle neutral position. This will be confirmed by LED 2 being
illuminated constantly.
3 .Move the throttle stick to the maximum forward position followed by a short
press on the Enter button again to calibrate the position. This will be confirmed
by LED 3 being illuminated constantly.
4 .Move the throttle stick to the maximum reverse position followed by another
short press on the Enter button to calibrate the position. This will be confirmed
by LED 4 being illuminated constantly.
Engine sounds produced will match the speed of the motor as set by the throttle stick.
The LEDs will show the RPM status 2 x Blue and 2 x Red LEDs illuminated
simultaneously indicate that maximum RPM has been reached.
A short press of the Enter button will increase the sound volume, and a short press of
the Esc button will to decrease the volume.
The motor will switch off automatically when the throttle has returned to Neutral for 5
seconds.
2. Calibration Mode
Once the calibration is complete the unit will emit a long beep.
Should the calibration be unsuccessful for any reason a series of 3 beeps will be
heard. It will then be necessary to repeat the steps above to re-calibrate the unit.
If you wish to exit the calibration process for any reason, simply give a long press on
the Enter button. A series of 3 beeps will be heard, confirming that the process has
been aborted.
3. USB Mode
USB mode can be used to update the sounds file and settings when the sound
system is connected to a computer via the supplied USB lead.
To enter USB mode connect the lead from the computer to the USB port and hold the
ESC button down (long press.) USB mode is confirmed by hearing 2 beeps and by
LED 3 flashing.
To exit USB mode either press and hold the ESC button or disconnect the cable.