User Manual

4. Attention
5. USB Settings
USB up:
Left: Input Channel
From up to down:
Right: Output Channel:
From up to down:
1. Direction Channel
2. Throttle Channel
3. First Loudspeaker Channel
4. Second Loudspeaker Channel
1. Direction Channel
2. Throttle Channel
3. First Loudspeaker Channel
4. Second Loudspeaker Channel
• Always assemble this system in accordance with this manual, ensuring that
all components are mounted securely.
• Low voltage alarm: If the voltage to the speaker drops below 6V, the first
(blue) and third (red) LEDs will flash.
• The loudspeaker unit should be installed in an area with a good cooling
airflow. Under no circumstances should this unit be covered.
• Always turn the volume down to minimum when first using or re-installing the
sound system to avoid damaging the units.
• Avoid placing components close to items with strong magnetic or
electromagnetic effects such as power cables and ESC’s.
• The control unit must be calibrated before first use and whenever used with
another radio transmitter.
When the device is connected to your computer it will show as a removable drive.
The following parameters may be edited:
• Brake: Brake sounds switch setting 1 = ON, 0 = OFF (Default ON)
• Rev limiter: Overload sounds switch 1 = ON, 0 = OFF (Default OFF)
• Rev limiter delay: Overload sounds played delay time - 1~9 seconds (Default 5
seconds)
• Idle: Engine idle sounds will run for a pre-determined time when the throttle is
returned to neutral (1~9 seconds) and then switch off. 1 = ON 0 = OFF (Default
ON)
• Idle delay: Automatic delay time 1~9seconds (Default 5 seconds)
• Battery type: 0 = LiPoly 1 = LiFe 2 = NiMH (Default LiPoly)
• Battery cell count: LiPoly/LiFe: 2~6cells, NiMH: 4~15cells (Default NiMH)