User Manual

ImmersionRC | EzUHF JR Module Manual Supplement
7
Note that the FatShark ‘Trinity’ head tracker is highly recommended for use with the EzUHF system.
This is really a best-in-class headtracker which uses sensors with 9 degrees of freedom, and absolutely
zero drift.
Binding
Once the firmware revisions of the Tx and Rx have been verified, and upgrades performed, the
transmitter may be bound to an EzUHF receiver.
To start the binding process, switch the power switch on the EzUHF JR module to Low power, while the
radio is turned off.
Hold down the binding button, and turn on the radio. Keep the button held down until the radio starts
beeping periodically. This indicates that the Tx is in bind mode.
Power up the receiver, and press the bind button on the receiver. The LED on the receiver will go out
while binding is in progress, but then, assuming binding is successful, the LED will start ‘breathing’
indicating a successful bind.
A failed binding is indicated by 6 flashes of the LED on the Rx. If this occurs, ensure that the firmware
versions match between Tx and Rx, and also ensure that the frequency band band matches.
Once bound successfully, cycle power to both the transmitter, and receiver, and ensure that the LED on
the Rx is still ‘breathing’.