User Manual

ImmersionRC | EzUHF JR Module Manual Supplement

Typically, the band does not need to be changed from its default setting. Examples of when it should be

changed are:

- When flying with other LRS users, to avoid the frequency band used by them

- When flying in RF-polluted areas, with strong interfering transmitters

Remote Power Switch

The Remote Power Switch allows a channel from the R/C transmitter to be used to change the output

power level of the EzUHF transmitter.

Not commonly used, it is best left at its default setting, which uses the power switch on the back of the

module to change between the two power levels.

Head Tracking

There are various settings which define the behavior of the head tracking support.

These allow mapping of source channels (channels on which the headtracker emits the pan/tilt/roll

controls), and the destination channels (channels which are sent to the EzUHF Rx).

A switch also allows the headtracker to be optionally enabled/disabled with the bind button on the

module.

The head-tracker port may also be used to power a set of FatShark goggles, eliminating the need for a

separate battery.