User Manual

4. Operation Instructions
After setting up, follow the instructions below to operate the system.
4.1 Power On
Follow the steps below to turn on the system:
1. Check the system and make sure that:
• The batteries are fully charged. (Charge the system via USB cable)
• The receiver is off and correctly installed.
2. Hold the power buttons until screen lights up.
3. Connect the receiver power supply to the
VCC and GND
port on the receiver.
The system is now powerd on. Operate with caution, or serious injury could result.
4.2 Binding
4.3 Pre-use Check
Before operation, perform the following steps to check the system:
1. Check to make sure that all servos and motors are working as expected.
2. Check operating distance: one operator holds the transmitter, and another one moves the model
away from the transmitter. Check the model and mark the distance from where the model starts to
lose control.
Danger · Stop operation if any abnormal activity is observed.
Danger · Make sure the model does not go out of range.
Attention · Sources of interference may affect signal quality.
4.4 Power Off
Follow the steps below to turn off the system:
1. Disconnect the receiver power.
2. Hold the transmitter's power buttons to turn off the transmitter.
Danger
· Make sure to disconnect the receiver power before turning off the transmitter.
Failure to do so may lead to damage or serious injury.
The transmitter and receiver have been pre-bound before delivery. If you are using another
transmitter or receiver, the steps below outline the binding process.
1. Hold the power button until screen lights up.
2. Press to open the system menu, scroll down and select "RX Bind", the transmitter will display
"Binding to RX......".
3. Supply power to the receiver. When the receiver is rst powered on it will remain in bind
mode for 5 seconds.
After successfully binding the transmitter will display "Bind ok !". The transmitter will then
automatically return to the previous menu.