User Manual

6.8 Output Mode
The system has four output modes, PWM 、 PPM、i-BUS and S-BUS compatible.
To change between the modes touch the desired mode, the currently selected mode will have a black dot
within the circle beside it.
Select the
icon to save and return to the previous menu.
6.9 Stick Mode
The system has 4 stick modes to change from, to change the mode touch M1, 2, 3 or 4 on the right hand
side of the screen. The currently selected mode is highlighted in black.
Mode 1 Mode 2
Rudder
Elevator
Aileron
Throttle
Rudder
Throttle
Aileron
Elevator
Mode 3 Mode 4
Aileron
Elevator
Rudder
Throttle
Aileron
Throttle
Rudder
Elevator
6.7 LED Setup
This function controls the LED's located inside the gimbal. When Idle color mode is off, the system will
change colour depending on vertical stick position. When Idle color mode is active the system will
maintain a single colour, touch the RGB sliders to change the color.
Then select the icon to save and return to the previous menu, select 'Y' when prompted.