User Manual

11
6.4 Subtrim
Subtrim changes the center point of the channel. For example, if a model is always drifting to one side,
the sub trim can be used to fix this.
To set the subtrim function:
To change the subtrim:
1. Touch the box to the right of the desired channel.
2. Select the correct decimal and use the up and down arrow keys.
3. Press the or to confirm or cancel changes.
4. Select the
icon to save and return to the previous menu.
6.5 Failsafe
The failsafe function enables you to pre-set channel positions for the receiver in case of signal loss.
Setup:
1. To setup a failsafe position on a channel, select the channel from the
list, to select the channel touch the box to the right of the channel
name.
2. The box next to the channel name should display "On", to activate the
failsafe touch the box. The box should now display "Off".
3. Move and hold the channel at the desired position, then while keeping
the channel at the desired value touch the setup box.
Set all:
It is possible to set all the channels at the same time, to do so first turn
all the channels on as stated above, hold all the channels in the desired
position and select "Set all" at the bottom of the list. The system will
prompt for a comfirmation, select "Y" for yes.
To Reset all channels, select the "Reset all" option.
Select the
icon to save and return to the previous menu.
6.6 Bri./Sound
This function controlls screen brightness and volume for the
system.
To make changes to brightness or volume touch and drag
the black box located within the relavent slider. Then select
the icon to save and return to the previous menu.