User Manual

Auto-charge current limit: When charging NiCd or NiMH at ‘AUTO’current
mode, you can set the upper limit of change current to avoid from high
current charging. This is very useful when charging the low impedance and
small capacity NiMH battery in “AUTO’mode.
Capacity limit: The changing capacity always calculated by multiple of the
charging current and time. If the charging capacity exceeds the limit the
process will be terminated automatically when you set the maximum value.
Temperature limit(*): The temperature of the battery on charging will rise by
its internal chemical reaction. If you set the limit of temperature the process
will be expired forcibly when the limit has reached.
Processing time limit: you can also restrain the maximum process time to
prevent from any possible defect.
Input power monitor: To protect the car battery using as input power from
being damaged the voltage of it always monitored. If it dorps below the lower
limit the process will be ended automatically.
Automatic cooling fan: The electric cooling fan comes into action automati-
cally only when the internal temperature of the unit is raised.
Data store/load
For users convenience it can store maximum 5 data of different batteries.
You can establish the data contains program setting of the battery to charge
or discharge continually. These data can be called out at any time you need
and the process can be executed without program setting.
Cyclic charging/discharging
Perform 1 to 5 cycles of charge>discharge or discharge>charge continually
for battery refreshing and balancing.
PC based analysis using USB communication(**)
For technical expert, it offers PC based program can analyse the characteris-
tic of the battery by USB port. It shows a graph of voltage, current, capacity
and temperature curves. It also shows the individual voltage of each cell in
the Lithium battery pack.