User Manual

-
9
-
7. Lithium battery(Lilo/LiPo/LiFe/LiHV)program
When you are willing to alter the parameter value in the program, press Start/
Enter key to make it blink then change the value with INC or DEC key. The value will
be stored by pressing Start/Enter key once.
7.1 Charging Lithium Battery
The left side of the first line shows the type of battery
you select at the users setting. The value on the left
side of second line sets a charge current and the value
on the right side of second line sets the voltage of the
battery pack.
After setting the current and voltage press Start/Enter
key for more than 3 seconds to start the process.
(Charge current:0.1~6.0A,Voltage:1~6 series)
Use these programs only when charging a lithium battery ( Lilo/LiPo/LiHV/LiFe) with
a nominal voltage of 3.6V, 3.7V, 3.8V or 3.3V per cell, respectively. The charge current
going into the battery will vary depending on the chemistry type so it is VERY
IMPORTANT that you select the correct type for your battery. The ending voltage
of the charge is also important as it varies for all four types:4.1V for Lilo, 4.2V for LiPo,
4.35V for LiHV and 3.6V for LiFe. The charge current (how many Amps you are
putting into the pack) and nominal voltage(Proper voltage for the cell count of the
battery you are charging) must be correct for the battery to be charged. To change these
settings, press the START/ENTER key to make the selected value blink. Using the
increase and decrease buttons, set you desired amperage, then press START/ENTER
to save the setting. You will then be asked to select your nominal voltage/cell
count. Again, use the increase/decrease buttons to reach your desired setting and
press the START/ENTER button to confirm and save.
The relationship between the C value and the charging time: charging time≥
60min/charging c value(for example, it need 60-70 minutes to complete 1C charging ).Due
to battery differences in energy efficiency conversion, this time may be extended.