User Manual

Auto-charge current limit: When charging NiCd or NiMH at
‘AUTO’current mode, you can set the upper limit of change current
to avoid from high current charging. This is very useful when charg-
ing the low impedance and small capacity NiMH battery in
“AUTO’mode.
Capacity limit: The changing capacity always calculated by
multiple of the charging current and time. If the charging capacity
exceeds the limit the process will be terminated automatically when
you set the maximum value.
Temperature limit(*): The temperature of the battery on charging will
rise by its internal chemical reaction. If you set the limit of tempera-
ture the process will be expired forcibly when the limit has reached.
Processing time limit: you can also restrain the maximum process
time to prevent from any possible defect.
Input power monitor: To protect the car battery using as input power
from being damaged the voltage of it always monitored. If it dorps
below the lower limit the process will be ended automatically.
Automatic cooling fan: The electric cooling fan comes into action
automatically only when the internal temperature of the unit is
raised.
Data store/load
For users convenience it can store maximum 5 data of different
batteries. You can establish the data contains program setting of the
battery to charge or discharge continually. These data can be called
out at any time you need and the process can be executed without
program setting.
Cyclic charging/discharging
Perform 1 to 5 cycles of charge>discharge or discharge>charge
continually for battery refreshing and balancing.