User Manual

NiMH/NiCd battery program
These programs are for charging or discharging NiMH (Nickel-Metal-
Hydride) or NiCd (Nickel-Cadmium) battery commonly used for R/C model
aplications. To alter the value at the display, press Start/Enter key to make it
blink then change the value using INC or DEC key.The value will be stored
by pressing Start/Enter key once.
To start the process, press Start/ Enter button for more than 3 seconds.
Charging NiCd/NiMH battery
This program simply charge the battery using
the current you set. In ‘Aut’ mode, you need to
set the upper limit of charge current to avoid
from higher feeding current that may damage
the battery. Because some batteries of low
impedance and small capacity can lead to the
higher charge current by the processor at
automatic charge mode. But in‘Man’ mode, it
will charge the battery with the charge current
you set at the display. Each mode can be
switched by pressing INC and DEC button
simultaneously when the current field is
blinking.
The screen displays the current state of
charging . To stop the process, press Batt
type/Stop key once.
The audible sound indicates you the end of
process.
Discharging NiCd/NiMH battery
Set discharge current on the left and final
voltage on the right. The discharge current
ranges from 0.1 to 1.0A and the final voltage
ranges from 0.1 to 25.0V). To start the
process, press Start /Enter key more than 3
seconds
The screen displays the current state of
discharge. You can alter the discharge current
by pressing StartEnter key during the process.
Once you change the current value, store it by
pressing Start /Enter button again.