User Manual

The screen shows the present situation during
charge process. To stop charging press Batt
type / Stop key once.
‘FAST’ charging Lithium battery
The charging current is getting smaller as the process goes to the near end
term of Lithium battery chaging. To finish charging process earlier, this
program eliminate certain term of CV process. Actually, the charging current
will goes to 1/5 from the initial value to end the process while the normal
chaging goes to 1/10 during CV term. The charging capacity may be a bit
smaller than normal charging but the process time will be reduced.
You can set up the charging current and the
voltage of the battery pack being charged. As
you press Start/ Enter button the voltage
confirmation will be displayed. And then, if you
confirm the voltage and current, press Start/
Enter button again to start charging.
This shows the present state of
‘FAST’charging. To stop charging arbitrary,
press Batt type/ Stop key once.
‘STORAGE’ control Lithium battery
This is for charging or discharging Lithium battery not to be used for the time
being. The program will determine to charge or discharge the battery to the
certain voltage depending on the voltage of the battery at its initial stage.
They are different from the type of the battery, 3.75V for Lilo, 3.85V for LiPo
and 3.3V for LiFe per cell. If the voltage of battery at its initial stage is over
the voltage level to storage, the program will start to discharge.
You can set up the current and the voltage of
the battery pack to be charged. The current will
be used for charge or discharge the battery to
reach the ‘storage’ level of voltage.