User Manual

This shows the number of cells you set up and

the processor detects.‘R:’ shows the number

of cells found by the charger and ‘S：’is the

number of cells selected by you at the previous

screen. If both numbers are identical you can

start charging by press Start/Enter button. If

not, press Batt Type/Stop button to go back to

previous screen. Then carefully check the

number of cells of the battery pack to charge

again.

The screen shows the present situation during

charge process. To stop charging press Batt

Type/Stop key once.

Charging Lithium battery at balance mode

This is for balancing the voltages of Lithium batteries of the battery park to be

charged. The battery pack to be charged should be connected to the suitable

balance port at the right side of the charger. And also, you need to connect

the battery output plug to the output of charger.

In this mode, the charging process will be different from ordinary charging

mode. The internal processor of the charger will monitor the voltages of each

cell of the battery pack and controls charging current that is feeding to each

cell to normalise the voltage.

The value on the left side of second line sets a

charge current and the value on the right side

of second line sets the voltage of the battery

pack.

After setting the current and voltage press

Start/ Enter key for more than 3 seconds to

start the process.

(Charge current:0.1~5.0A, Volatge:1~6 series)