User Manual

This program sets the maximum charge
capacity that will be supplied to the battery
during charge. If the delta-pack voltage is not
detected nor the safety timer expired by any
reason, this feature will automatically stop the
process at the selected capacity value.
The beep sounds at every time pressing the
buttons to confirm your action. The beep or
melody sounded at various times during
operation to alert different mode changes.
These audible sounds can be on or off.
This program monitors the voltage of input
battery. If the voltage drops below the value
you set the operation forcibly terminated to
protect the input battery.
Lithium battery(Lilo/LiPo/LiFe)program
These programs are only suitable for charging and discharging Lithium
batteries with a nominal voltage of 3.3V, 3.6V and 3.7V per cell. These batter-
ies need to adopt different charge technique is termed a constant
voltage(CV) and constant current(CC) method. The charge current varies
according to the battery capacity and performance. The final voltage of
charge process is also very important; it should be precisely matched with
the charade voltage of the battery. They are 4.2V for LiPo, 4.1V for Lilo, and
3.6 V for LiFe. The charge current and nominal voltage as for cell count set
on the charge program must always be correct for the battery to be charged.
When you are willing to alter the parameter value in the program, press
Start/Enter key to make it blink then change the value with INC or DEC key.
The value will be stored by pressing Start/Enter key once.
Charging Lithium Battery
The left side of the first line shows the type of
battery you select at the users setting. The
value on the left side of second line sets a
charge current and the value on the right side
of second line sets the voltage of the battery
pack.
After setting the current and voltage press
Start/Enter key for more than 3 seconds to
start the process.
(Charge current:0.1~5.0A,Voltage:1~6 series)