User Manual

Both – Plays two files using only one switch. When the switch is turned ON, it might, for
example, play file 0100.wav, and then when the switch is turned OFF, would play the next
consecutive file, 0101.wav. Each file will play only once for a given pair of switch
movements. Note that this option requires that the on and off audio files have consecutive
numbers. Using this feature, you only have to program the “on” file number.
15 / 30 / 60 Seconds – This option will play the selected file number every 15, 30, or 60
seconds when the trigger switch is on.
Varibl – When you select this option, a telemetry event will be played once when the trigger
switch is on. In this case on the right side instead of file numbers you will have a choice of
telemetry events: e.g.,: A1=, A2=, Alt, RPM, etc...
Examples
Using a Two-Position Switch to Play Voice Files
How to program a voice switch that will play a voice once:
VS20 THR ON 172
This will say ‘Thermal Mode’ when the THR switch is turned ON.
How to play a voice file once when the switch is ON and the consecutive file number when the
switch is OFF:
VS24 GEA BOTH 150
In this case, when you turn the GEA switch ON, voice file 0150.wav will be played (Landing gear
up) and when you turn the GEA switch OFF voice file 0151.wav (Landing gear down) will be
played.
Using the Three-Position Switch
How to program a 3-position flap using ID0, ID1 and ID2. This one is a bit tricky but uses only two
voice switch to play three different voice files at appropriate times.
Voice files used are:
0144 “Flaps up” When ID0 is on
0145 “Flaps 1” When ID1 is on
0146 “Flaps 2” When ID2 is on
0147 “Flaps 1” When going from ID2 back to ID1.
For this to work, on the SD card you will need to make a copy of file “Flaps 1”, i.e., 0145.wav,
rename it 0147.wav and place it after the file for ID2 (0146.wav).
The relevant files on the SD card will then be:
0144.wav “Flaps Up”
0145.wav “Flaps 1”
0146.wav “Flaps 2”
0147.wav “Flaps 1”
We use two consecutive Voice Switches say VS10 and VS11 like so:
VS 10 ID0 BOTH 144
This will play the file 0145 (Flaps 1)when the switch is moved to the middle position (ID1) and 0144
(Flaps Up) when it is moved back to ID0.
VS 11 ID2 BOTH 146
This will play the file 0146 (Flaps 2) when the switch is moved from ID1 to ID2. When the switch is
moved back to ID1, the file 0147 (Flaps 1) will play. That's why a renamed copy of the file for ID1
must be placed right after the file for ID2.
Ersky9x Voice Explained: Version 1 page 4 of 12