User Manual

Assembly of the Module
One end of the circuit board has the corners removed to fit the pillars in the box for the back cover
screws. Place the circuit board inside the box and carefully push it to the bottom so that it rests
parallel with the bottom of the box. Be careful not to apply force to the antenna cable and clip.
Using a thumb at each end push the circuit board until it engages the detents.
At the end adjacent to the switches, the cover has tags which slot into the module box. Insert these
tags holding the other end at a slight upward angle. Ensure that the switches align with the
openings in the cover and close the top end of the cover, making sure the antenna cable is free
inside the box. Insert and tighten the screws.
If you have more than one DJT module, mark this one as being modified.
Use of the Module
In addition to the Turnigy 9XR Pro, this module may be used with the FrSky Taranis and the SKY
9x boards. It should NOT be used with the regular Turnigy 9XR or the various 9x transmitters, as
the pin connections are not compatible.
9XR Pro: Introduction to the Hardware: version 1 12